The use of resin grinding wheels must be carried out in accordance with certain regulations, otherwise the grinding quality will be seriously affected. The following editor will introduce the precautions for the use of resin grinding wheels.
1. Before using the resin grinding wheel/strong>, be sure to check whether the product has cracks, products and hoarseness. If there is, it cannot be used.
2. The grinding wheel speed shall not exceed the specified safe working line speed.
3. Do not use the end face working grinding wheel specially, please do not work with the end face of the grinding wheel.
4. When the grinding wheel is processing the workpiece, please do not push the workpiece with a lever to increase the pressure on the grinding wheel.
5. Special dressing tools should be used to dress the grinding wheel. When repairing, the operator must wear protective glasses.
6. In the grinding process, the coolant should be selected correctly. If the coolant is not used, there must be a dustproof device.
7. Each resin grinding wheel/strong> is marked with the maximum use and line speed. Before installing the machine, be sure to confirm the speed of the machine, and do not exceed the speed marked on the grinding wheel. Make sure that the machine is well protected. The center hole of the grinding wheel and the center axis of the grinding wheel must match, otherwise it cannot be used.
8. The shape and size of the flanges clamped on both sides of the resin grinding wheel must be the same. The diameter of the flange should meet the requirements, and there should be grooves on both sides.
9. When installing and fixing, it must be properly tight. After the installation is completed, start the machine to idle for about a minute, and use it only after there is no abnormality.
10. Whether it is grinding, the pressure given during use should be uniform. It is strictly forbidden to collide violently with the workpiece when the grinding wheel/strong> is adjusted and rotated. When entering the knife, go slowly and gradually. When cutting large-diameter workpieces, it is necessary to reduce the contact surface between the grinding wheel and the workpiece.
